[amsat-bb] TH D72
johnbrier at gmail.com
Wed Jan 13 21:40:14 UTC 2016
I suppose this is because, as others have said, to do duplex you have
to use one side for TX and one side for RX and the sats don't use the
same bands for RX/TX. (Just confirming I understand the problem).
With Kenwood radios there is a way to transfer memories to VFO. I
wonder if you just saved each sat's RX and TX if you could transfer
the memory with at least tone, and hopefully step, to the appropriate
side of the radio. I can't remember the buttons to do this, but on
some Kenwood radios it is as simple as Function -> VFO
On Wed, Jan 13, 2016 at 3:26 PM, Zach Hillerson
<zach.hillerson at gmail.com> wrote:
> Thanks for the replies. I don't mind having to manually enter the
> appropriate frequency and have had zero issues following ao85 and so50
> through full passes.
> The issue that drives me crazy is having to reset the tone and step each
> time I change satellites. If I have everything set with a 67hz tone and
> 5khz step for an ao85 pass and then enter frequencies for a so50 pass I
> have to redo the tone and steps. It automatically defaults each time to
> 88.5 and 25khz steps.
> I don't know what to do to make this not have to occur. I would prefer to
> just type in the appropriate frequencies and move on, not have to make the
> other adjustments.
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB