[amsat-bb] ICOM 706G phase noise
n8hm at arrl.net
Fri Oct 31 17:34:56 UTC 2014
Try a diplexer on either the transmit or receive side (whichever works
better) with the common port to the antenna, the appropriate band port
hooked to the radio, and the other band port left disconnected. If
your Icom is putting something out on 2m when transmitting on 70cm,
that should filter it out.
On Fri, Oct 31, 2014 at 12:41 PM, David G0MRF <g0mrf at aol.com> wrote:
> Hi all.
> Inspired by the FUN on the YouTube videos from the car park at Baltimore, I've been trying to set up a satellite station using two independent radios. An IC706G on 70cm transmit and an FT736R on 2m receive.
> Antennas are a 4 ele yagi ( horizontal ) on 2m receive with an AMSAT-UK filtered preamp. Transmit antenna is a 9 ele Tonna mounted vertically.
> Antennas are on a rotator using a fibreglass boom about 1.8m long.
> The problem: Whenever I press the 70cm transmit 'button' - ptt on SSB, or key on CW I get S8 noise on the 2m receiver. (and S6 without the preamp)
> Note...This does not appear to be RF overload as I can turn the power down to minimum on SSB, even remove the microphone and the noise level remains.
> On CW the noise level is constant when the 706 is in transmit mode. It does not appear and disappear with each dot or dash.
> My conclusion is that on 70cm the IC706G is transmitting something on 2m whenever it is in it's transmit mode.- possibly phase noise.
> Has anyone else come across this issue with ICOMs or is it just this one? and is there a known minimalist solution.
> Many thanks
> David G0MRF
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB