[amsat-bb] Re: Yaesu G-5500 Wiring

Jim Jerzycke kq6ea at verizon.net
Sun Apr 20 17:00:20 PDT 2014

 From the manual:

Connect each wire to the terminals on the
rear panel of the controller, making sure to
match the numbers on the pins......

So, yes, it's 1-1, 2-2, 3-3, etc


On 04/20/2014 11:30 PM, David Rush wrote:
> I've got a used set of Yaesu G-5500 az/el rotors, and the plugs that 
> attach to the rotor housings.  I need to build cables to connect them 
> to the Yaesu controller.
> Page 3 of the instruction manual shows some info about the wiring, but 
> doesn't explicitly say which screw terminal on the controller goes to 
> which pin on the rotor plugs.
> Is it simply 1-1, 2-2, ... 6-6?
> David, ky7dr
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite 
> program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

More information about the AMSAT-BB mailing list