# [amsat-bb] Re: G5500 Rotor motor Question

i8cvs domenico.i8cvs at tin.it
Sun Apr 28 09:35:57 PDT 2013

```----- Original Message -----
From: "Mike Hoblinski" <hobergenix at sbcglobal.net>
To: <amsat-bb at amsat.org>
Sent: Sunday, April 28, 2013 7:55 AM
Subject: [amsat-bb] G5500 Rotor motor Question

> Anybody know what the rpm of the AC motors are. I know from the Yaesu
> specs that after all of the gear reduction they list EL as 67 seconds for
> EL and 58 Seconds for AZ.
>
> I would like to experiment with an AZ and EL system but like to see what
> RPM the motor starts out with and how much torque to get the final
> results. They show Elevation at 101 FT-LBS and AZ at 44 FT-lbs.
>
> I have looked around to see if somewhere the specs are available for the
> motor but have had no luck. I have seen quite a few pictures of rebuilds
> of that rotor with part number and have a manual that shows parts.
>
> Mike Hoblinski
>
> N6IMF
>
Hi Mike, N6IMF

The EL and AZ motors of a G5500 rotator are 2 pole (P) squarrel cage AC
asynchronous motors because the stator is wound with 4 coils and each
couple of 2 coils is positioned 90 degrees with respect to the other couple
of 2 coils.

The RPM (revolutions per minute) of a asynchronous motor is given by the
following formula:

f x 60
RPM = -------------  - S
P

where:

f    = value of the frequency in Hz of the supply AC power
60 = 60 seconds into a minute
P   =  number of poles of the motor
S   =  speed of gliding  ( 7 % for small motors )

If you supply the motor with 24 volt 60 Hz as in USA than

60 x 60
RPM = -------------- = 1800 - 7% = 1674
2

I hope this helps.

73" de

i8CVS Domenico
```