[eagle] Re: CAN-Do Suggestions from Juan

[Jim Sanford]

DIck:
Do you know where any exist?  Let's get them in Juan's hand and SEE.
73,
Jim


Dick Jansson-rr wrote:

> Juan:
>
>  
>
> You keep commenting on the flexure of the PCB and relate it to the 
> module hardware that you have in hand. It is my very greatly 
> considered opinion that the baseplate that you have has been modified 
> (butchered) to allow for the soldering of the CAN 40pin connector and 
> this has created not only reduced sections in this plate, but probably 
> has also distorted the plate considerable. Such distortions in all 
> likelihood have created a non-normal flexure condition in that 
> particular plate. As such, your opinion of the design has been biased, 
> and that is unfortunate. It seems to me that you should try to acquire 
> an E05 21 base plate that is in "stock" condition. I don't have any in 
> hand here in Florida, or I would have sent it to you some time ago. 
> These parts, unfortunately are in a limited supply at this time.
>
>  
>
> '73,
>
> Dick Jansson, KD1K
>
> kd1k at amsat.org <mailto:kd1k at amsat.org>
>
> kd1k at arrl.net <mailto:kd1k at arrl.net>
>
>  
>
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>Via the Eagle mailing list courtesy of AMSAT-NA
>Eagle at amsat.org
>http://amsat.org/mailman/listinfo/eagle
>  
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://amsat.org/mailman/private/eagle/attachments/20070717/7fcc532c/attachment.html