[amsat-bb] FalconSat-3: UZ7HO's Soundmodem Full Duplex Mode
scott23192 at gmail.com
Fri Oct 6 17:44:20 UTC 2017
Don't have an answer for you but I'm really glad to see your message. I
have been experimenting offline with TX through the UZ7HO high-speed
soundmodem using recorded FalconSat-3 9k6 data for my RX stream. However, I
hit a roadblock with the DCD... I could only transmit when there was no
incoming data detected, which is very rare!
As for your live, on-air testing, have you tried any APRS messaging
transmissions instead of attempting to access the BBS?
Montpelier, VA USA
Sent: Friday, October 06, 2017 1:35 PM
To: amsat-bb at amsat.org
Subject: Re: [amsat-bb] FalconSat-3: UZ7HO's Soundmodem Full Duplex Mode
I tried accessing Falconsat-3's BBS via PFS3-12 this afternoon, but I
wasn't able to connect. I'm using Easyterm with an experimental
full-duplex sound card modem by UZ7HO. This version has it's DCD
disabled to allow full-duplex operation.
Assuming the BBS is turned on, are there any special parameters needed
when using a simple terminal program? It would be nice to use Wisp
again, but I don't see a way to use a sound card modem with this program.
More information about the AMSAT-BB