kq6ea at verizon.net
Mon Feb 20 02:47:20 UTC 2017
DX Engineering sells very good rotor cable, as does Davis RF.
And there's always eBay or Amazon.....
73, Jim KQ6EA
On 02/20/2017 02:17 AM, Jerry Buxton wrote:
> If it's a fairly short run, maybe CAT-5? If it's a little longer run,
> maybe twist 4 pairs and run a CAT-5 for each rotator?
> Jerry Buxton, NØJY
> On 2/19/2017 19:53, Joe wrote:
>> Any good suggestions for cheap 8 conductor rotor cable?
>> I'm gonna use two of the alliance U-110 rotors, and they are 4
>> conductor rotors. soooo, need 8.
>> Joe WB9SBD
>> The Original Rolling Ball Clock
>> Idle Tyme
>> On 2/19/2017 6:34 PM, Wendy and Terry Osborne wrote:
>>> Hi Joe,
>>> Vertical works fine but man made noise is mostly vertically polarised
>>> so you will get a bit more of that.
>>> With horizontal, you have more problems with ground reflection so you
>>> get more fading.
>>> Depending on how big your metal cross boom is you will have no
>>> problems on 2M.
>>> On 70CMs the metal boom upsets the gain/radiation pattern. I tried
>>> this with a 2"" cross boom and it didn't
>>> work well at all. A shorter yagi, end mounted worked much better.
>>> Terry ZL2BAC
>>> -----Original Message----- From: Joe
>>> Sent: Monday, February 20, 2017 6:05 AM
>>> To: amsat-bb
>>> Subject: [amsat-bb] Antennas
>>> Weather is nice,
>>> Time to put up antennas.
>>> Now I know most like to go CP, But I'm on a limited budget. So it will
>>> need to be a traditional linearly polarity yagi,
>>> Of course I can mount them vertically or horizontally polarized.
>>> And if it was just one band, is there ny preference to vert or horiz?
>>> I don't see any, except from the man made noise issue when on low
>>> is there any best polarity?
>>> I'm planning on a side by side 2 meter and 70 cm set up
>>> 2 meter vertically polarized on one end of a cros boom, and the same on
>>> the other side but 70 cm.
>>> This way I can get away with using a metal cross boom.
>>> Joe WB9SBD
>> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
>> to all interested persons worldwide without requiring membership.
>> Opinions expressed
>> are solely those of the author, and do not reflect the official views
>> of AMSAT-NA.
>> Not an AMSAT-NA member? Join now to support the amateur satellite
>> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB