[amsat-bb] Re: balun and phasing lines for M2 436cp30 and 2mcp14
normanlizeth at gmail.com
Mon Jan 20 08:24:38 PST 2014
Compression fittings from home depot work. I have the baluns and phasing
gear for both your antennas, as I have a set myself. The436cp30 ones are
off and I can measure them directly. However the 2m antenna is on the
tower. I will have that down in a few days. Will make measurements for you.
On Mon, Jan 20, 2014 at 10:38 AM, Floyd Rodgers <kc5qbc at swbell.net> wrote:
> Probably not quite the quality, but I was planning to use compression
> fittings and tool from Home Depot since I have both.
> Any hints on length or the design frequency? Guess I could construct based
> on where I plan to use them.
> That reminds me of the months I've been waiting on ball bearings for the
> Yaesu az/el rotor which is why the antennas were on the ground where the
> beasts live. Four pits actually defend them from other things pretty well,
> and you wouldn't believe what they can do to 7/8 hardline.
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB