[amsat-bb] Re: SatPC32 ISS help needed
k7trkradio at charter.net
Thu Dec 12 12:26:49 PST 2013
Found the buttons ! that was the issue
Thanks, Alan and Erich too
Merry Christmas to all
From: amsat-bb-bounces at amsat.org [mailto:amsat-bb-bounces at amsat.org] On
Behalf Of Alan
Sent: Thursday, December 12, 2013 4:57 AM
Subject: [amsat-bb] Re: SatPC32 ISS help needed
I do not have an FT-847 handy to test, but here is some information.
The TX/RX buttons have been moved. At the very bottom line, Obs, Config,
etc, hover your mouse. You will get a message to "Double click to
activate/deactivate RX/TX buttons." They will appear in the corners of the
I have a full complement of help files, including one for SatPC32ISS in the
Are you using Configuration 1? SatPC32ISS picks up most of its information
from SatPC32, and in the past I found it did not get the correct radio
information if I was using Configuration 2.
Finally, check the frequency update interval, main program. If you have the
FM update set to 100 Hz, it may take a significant time except during a pass
for the Doppler to shift enough to update.
<From: amsat-bb-bounces at amsat.org
<[mailto:amsat-bb-bounces at amsat.org] On Behalf Of Ted
<Sent: Wednesday, December 11, 2013 6:31 PM
<Subject: [amsat-bb] SatPC32 ISS help needed < <HI < < < <I cannot seem to
get the ISS portion of the program to operate <properly with
<1. Regular SatPC32 program works as it should
<2. In ISS, I have CAT control (trigger on/off with C
<3. SAT on the radio is turned off
<4. In CAT, I can select the pair for the repeater and the
<will appear on the radio (VFO A) The initial freq in the <program appears
but <does not update further < < <
< 5. Manual says "With the Yaesu FT-847 only use the 'TX' / 'RX'
<controls of SatPC32ISSto switch
< the radio to TX
<or RX, rsp.
<Otherwise the VFO can't be tuned to the TX frequency <
< before the radio
<is switched to
< Program is not displaying TX/RX buttons or
<controls nor am I
<able to key tx with + or - keys on 10 key pad < < <
<6. FYI, there are no files shown in any o the aux files.
<(but, I suspect
<that info is pulled from the main program) < < <
< I must have something set wrong. Any help appreciated
<Sent via AMSAT-BB at amsat.org. Opinions expressed are those of <the author.
<Not an AMSAT-NA member? Join now to support the amateur <satellite program!
<Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB