[amsat-bb] Re: Motor for Yaesu G5500 Azimuth Rotator?
quadpugh at bellsouth.net
Thu Feb 23 14:09:36 PST 2012
I have rewound the motors. It take a couple of hours but is doable. I went
to Radio shack and bought I think # 24 or 26 gale wire.
From: amsat-bb-bounces at amsat.org [mailto:amsat-bb-bounces at amsat.org] On
Behalf Of David Palmer KB5WIA
Sent: Thursday, February 23, 2012 8:32 AM
To: AMSAT BB
Subject: [amsat-bb] Motor for Yaesu G5500 Azimuth Rotator?
Well I'll be QRT from the sats for a little while!! After replacing
my UHF antenna on the backyard satellite array, I managed to catch the
(slightly longer) new antenna on the house roof and jammed the Yaesu
G-5500 rotator, ugh! Even though I had replaced the normal 2-amp
fuses in the controller with 1-amp fuses, the azimuth motor still
managed to overheat and burn out.
I disassembled the azimuth rotator, and although the gears, bearings,
switches, and capacitor are all OK, the motor has quite a burnt smell.
Bench-testing the unit with motor removed from the assembly shows the
motor doesn't spin at all in one direction, and spins slowly but draws
high current in the other. Coil windings are in series for
left/right, should be 3.5 + 3.5 = 7.0 ohms, and the right coil is
showing only 1.0 ohms resistance. The azimuth motor is definitely
toast. Fortunately, the controller is OK (both the Az and El sides
of the controller successfully control the elevation rotator).
I just got off the phone with Yaesu parts, and unfortunately the
replacement motor has been backordered from Japan since December. No
estimate yet of when more might come in.
Question to the list: does anyone have a G5500 azimuth rotator with a
working motor available for parts? Or any other ideas for
73! Dave KB5WIA
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB