[amsat-bb] Re: ARISSat TLM: Sample rate of Signalink
Alan P. Biddle
APBIDDLE at UNITED.NET
Sun Aug 7 07:17:15 PDT 2011
I have had exactly the same results, and yes, 48 kHz is correct according to
the program author. Based on reports I have received, and considerable
experimentation, it seems to be a poor performer in this mode. So far,
nobody has reported success with the unit on any radio. Other cards work
fine, even holding a microphone in front of the speaker. There is nice
discussion here about both internal noise and non-linear response issues,
and some fixes here:
I am retiring the unit, so will not be trying these modifications to see
whether that helps. From reports I have received, a simple audio patch
between the rig and a standard soundcard works well.
From: amsat-bb-bounces at amsat.org [mailto:amsat-bb-bounces at amsat.org] On
Behalf Of Werner, HB9BNK
Sent: Sunday, August 07, 2011 8:49 AM
Subject: [amsat-bb] ARISSat TLM: Sample rate of Signalink
While I have been decoding some frames in an earlier pass using
another pc, I have no luck using the Signalink USB attached to to
AF-Port on the IC910H (cw decoding works very well)
How can I verify it's sample rate and - if necessary - set it to
48 kHz ?
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB