[amsat-bb] Re: G-5400B Rotor / Elevation not working

Howard Kowall hkowall at shaw.ca
Tue Jul 28 18:14:10 PDT 2009

Hello Bob
Never had that problem
But a quick look at the circuit,and if the az is working.Sounds like a bad 
wire ,or contact if there is a plug on it
Check to make sure the wire on terminal#6 is ok
Good Luck

----- Original Message ----- 
From: "Bobby Lacey" <amsat at duaneallman.net>
To: <AMSAT-BB at amsat.org>
Sent: Tuesday, July 28, 2009 3:52 PM
Subject: [amsat-bb] G-5400B Rotor / Elevation not working

>I have a Yaesu G-5400B and the elevation side of the control box seems
> to have stopped working. The actual elevation rotor has also stopped
> responding as well. I hooked up a working elevation rotor to test and
> didn't get any response out of it. Has anyone experienced this or know
> of something I should look before before I start tracing the
> schematic?
> Please respond to me directly unless the list thinks this question
> warrants it's own thread.
> 73
> Bobby KF4GTA
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb 

More information about the AMSAT-BB mailing list