[amsat-bb] Re: Icom 910 and amp
glasbrenner at mindspring.com
Tue Feb 24 17:55:11 PST 2009
The manual is poorly written with regards to this feature, but Pin 3 on the
ACC jack grounds on TX. I break out all the pins to a terminal strip, then
use this to key my KJ6KO L amplifier.
73, Drew KO4MA
----- Original Message -----
From: "Gregory Dober" <gjdober at comcast.net>
To: <amsat-bb at amsat.org>
Sent: Tuesday, February 24, 2009 8:47 PM
Subject: [amsat-bb] Icom 910 and amp
> I'm looking to add an amp on VHF with an Icom 910 to do some weak signal
> work on the VHF bands. In addition, it may help my 23cm uplink on
> satellites. Since the 910 doesn't have an amp relay like most HF rigs,
> anyone have suggestions on the best way to wire. It appears that I have
> use the PTT/Ground in the microphone. Any suggestions or experience with
> this? Can e-mail me off board too at almetco (at) Comcast (dot) net.
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB