[amsat-bb] Re: IF-100 Interface
howard at howardlong.com
Sun Oct 19 06:24:57 PDT 2008
Check out the code in WispDDE:
Sub IF100RotorSetAzEl(Az, El, Port As Integer)
As Tony says, you need some nasties to talk straight to the parallel port.
You may already have that in HRD for other rotators like the FODTrack.
Cheers & 73, Howard G6LVB
From: amsat-bb-bounces at amsat.org [mailto:amsat-bb-bounces at amsat.org] On
Behalf Of Simon (HB9DRV)
Sent: 19 October 2008 10:45
Subject: [amsat-bb] Re: IF-100 Interface
I can be more specific - it's the strobing I need to set.
Simon Brown, HB9DRV
----- Original Message -----
From: "Simon (HB9DRV)" <simon at hb9drv.ch>
> Does anyone know how to drive the IF-100 via the parallel port? I am
> sure I am send the correct commands (I've looked in the WISP code) but
> am failing to get the hardware to recognise my commands. The same
> hardware works fine with an old DOS program.
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
More information about the AMSAT-BB