[amsat-bb] Re: IC-910H C-IV control port pinout?

jonny 290 jonny290 at gmail.com
Wed Dec 12 20:40:04 PST 2007

It's a mono bus - just data and ground.

If you have a couple of transistors and diodes sitting around you can 
build at least a one way interface, I put one on a
bit of PC board and it works great for both programming my 208h* and for 
controlling my 475.

*208h programming port is the right side of the audio output jack, 
rather than the center pin as in C-IV jacks

Rick Mann wrote:
> Does anyone have pinouts for the Icom IC-910H's C-IV port? I'm hoping  
> to fashion a USB-to-serial adaptor for it, rather than buying Icom's  
> expensive little box. I'm concerned, though, because it looks like it  
> uses a mono plug, so I don't know exactly how it communicates.
> TIA,
> Rick
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

More information about the AMSAT-BB mailing list